粉體行業在線展覽
粉體行業在線展覽
直接聯系
上海玉研科學儀器有限公司
意大利
面議
1022
顯微鏡物鏡加熱器OBJECTIVE HEATER
對顯微鏡物鏡進行加熱、保溫
Features
Temperature controlled heating band
Easy installation around the objective
Fits any objective on the market
Compatible with the following OKOLAB Controllers:
H301-T-UNIT-BL-PLUS
UNO-T-H-PREMIXED
UNO-T-H-CO2
H401-T-CONTROLLER
Compatible with Inverted and Upright Microscopes
Self CalibrationRoutines with BL controllers
Voltage: 24 V
Power: 13 W
When should I use an Objective Heater
You should use an objective heater， if you:
Perform Oil Immersion Imaging with a Top Stage Incubator
Use dipping lens with an upright Top Stage Incubator
Why should I use an Objective Heater?
Because， if you don't， sample temperature will drop due to oil contact with the cold objective， as shown in the following graph.
Step 1: Objective not in contact with Petri 2; Objective Heater Off.
Step 2: Objective in oil contact with Petri 2; Objective Heater Off.
Step 3: Objective in oil contact with Petri 2; Objective Heater on， Offset value 5.3°C.
During the self calibration routine， the offset value of the objective heater is progressively increased， until T2 reaches the desired set point temperature of 37.0°C.
Figure 3 reports the profile of T1， T2， and of Objective Heater Temperature during the experimental campaign described above.
請關注玉研儀器的更多相關產品。
如對產品細節和價格感興趣，敬請來電咨詢！
